Electronic starter device ÝÏÐÀ 220-11
It is needed for functioning and stabilization of operating modes of low pressure luminescent lamps, powered 7, 9 and 11 W, such as ÊËÓ7/ÒÁÖ, ÊËÓ 9/ÒÁÖ, ÊËÓ 11/ÒÁÖ or their foreign analogues.
Devices are designed on the basis of high-frequency oscillator with a pulse voltage stabilizer circuit; that gives an opportunity to carry out stabilization of a luminous flux.
Level of the radio noise of operating device meets requirements of ÃÎÑÒ 21177.
Climatic modification according to ÃÎÑÒ 15150 - ÓÕË, category of accommodation 4.2.
| Characteristics: |
| Frequency of transformation, kHz |
20...35 |
| Electrical shock protection rate according to ÃÎÑÒ 12.2.007.0-75 |
0,1 |
| Current consumption, max, A |
0,1 |
| AC power supply, V/Hz |
220/50 |
| Dimensions, max mm |
120õ40õ29,5 |
|
|
|
Structurally the transformer is a printed-circuit-board with electronic elements placed on it. The printed-circuit-board has clipses for connection to external circuits through wires up to 1.5 ìì2 in diameter. The printed-circuit-board is placed into a protective metal case, which is also used for fastening the transformer to various constructions.
Connection of devices with lamps is made according to fig.1
 Fig. 1
Structurally the transformer is a printed-circuit-board with electronic elements placed on it. The printed-circuit-board has clipses for connection to external circuits through wires up to 1.5 ìì2 in diameter. The printed-circuit-board is placed into a protective metal case, which is also used for fastening the transformer to various constructions.
Installation drawing is given in fig. 2
Fig. 2.
^
Copyright © 2003 ÐÓÏ "Ìèíñêèé çàâîä Êàëèáð"
Ïðîäâèæåíèå ñàéòà SunWeb.by
| 
