Electronic starter device ЭПРА 220-2x40, electronic ballasts БЭ 220-2x40, БЭ 200-2x65
It is intended for functioning and stabilization of operating modes of luminescent lamps of corresponding capacity.
Devices are designed using high-frequency oscillator with a pulse voltage stabilizer circuit as a basis, that allows to stabilize luminous flux.
Level of the radio noise of operating device meets requirements of ГОСТ 21177.
Electrical shock protection rate according to ГОСТ 12.2.007.0 - 0.
Climatic modification according to ГОСТ 15150 - УХЛ, category of accommodation 4.2.
A safety fuse, mented for 1 A current, is included into a power supply circuit.
| Characteristics: |
| № |
The name |
Capacity of connected lamps (W) |
Number of lamps, pcs. |
Current consumption, A |
Capacity factor (cosφ) |
Frequency transformation, kHz |
Start-up time, max s |
Start-up scheme |
| 1. |
ЭПРА 220-2х40 |
36; 40 |
2 |
0,45 |
0,92 |
40±5 |
1,5 |
Рис.1 |
| 2. |
БЭ 220-2х40 |
36; 40 |
2 |
0,45 |
0,92 |
40±5 |
1,5 |
Рис.2 |
| 3. |
БЭ 220-2х65 |
58; 65 |
2 |
0,7 |
0,92 |
40±5 |
1,5 |
Рис.3 |
|
|
|
Dimensions, max, mm 423x42x36,5
Connection of devices with lamps is made according to fig. 1 and 2.
Fig. 1. The communication chart of external connections 220-2x40
Fig. 2. The communication chart of external connections БЭ 220-2x40 and БЭ 220-2x65
Structurally the devices are printed-circuit-board with electronic elements placed on it. The printed-circuit-board has clipses for connection to external circuits through wires up to 1.5 мм2 in diameter. The printed-circuit-board is plased into a protective metal case, which is also used for fastening the devices to various constructions. The installation drawing is given in fig. 3.
Fig. 3.
^
Copyright © 2003 РУП "Минский завод Калибр"
| 
