Instruments for observing, measuring and examining signal waveform and spectrum (oscillographs).

• C9-27
• C9-8
• C8-23
• C8-38
• C1-142
• C1-117/1, C1-117/2

Dual-trace storage oscikkoscope C9-27

This high-speed dual-trace storage oscilloscope is designed to display, record and measure the parameters of two single or periodic signals.

Digital storage oscilloscope C9-8

The oscilloscope is designed for examining signal waveforms by visually observing them, measuring their amplitude and time parameters, with digital information about the parameters of the signals being measured and deflection factors displayed on the CRT screen and transmitted to the common-user channel (CUC) interface.

Digital storage oscilloscope C8-23

Two-channel small-sized storage oscilloscope C8-23 is intended for examination of periodic and single electric signals by visual observation on CRT display and measuring of their peak and time parameters both on CRT display and in a digital form. Operating mode and results of measurement are indicated on CRT display. Self-diagnostics. Digital storing and storage of signals.

Digital storing ocillograph C8-38

C8-38 is a general purpose digital storing ocillograph. It helps to examine signals in a range of frequencies up to 100 MHz. Ocillograph registers single signal with a maximum discretization rate 100 МHz per channel. The device carries out digital processing and storing of signals, thus making easier observing transient process, slow changing and single events.

Oscillograph universal C1-142

Universal small-sized oscillograph С1-142 with adjustable amplitude calibrator of voltage and increased size of display. It is intended for: visual observation of periodic electric signals and measurement of their amplitude and time parameters; substitutes oscillographs with a passband up to 50 MHz (such as С1-65, С1-114, С1-127, С1-117 and others). Unitary start of a sweep. An opportunity of simultaneous observation of three signals on the display: two channels of a vertical deflection and the calibrated channel of synchronization.

Universal oscillographs C1-117/1, C1-117/2

The oscilloscopes are designed for examining signal waveforms by visually observing them, measuring their amplitude and time parameters, displayed on the CRT screen, and in a digital form (for C1-117/1) , the results and dimensions of the measured parameters are displayed then on the light-emitting diode indicator. High sensitivity (0.1 mV/div). Synchronization with a TV signal.

^